Delta Printer Build
Delta Printer Build
Embedded Files
Original Specs
Original Specs
Hotend: E3d v6
Extruder: Bowden
Control Board: Ramps 1.4
Firmware: Reprap
Other: 12 volt, no part cooling fan, heated bed
September 06, 2025
September 06, 2025
Power on test of new control board.
Mainboard: BTT SKR Mini v3.0
Coprocessor: Raspberry Pi 3B+
Planned Firmware: Klipper
August 15, 2025
August 15, 2025
First benchy, printed on the original hardware. Not very good (more likely than not a failure in slicer settings than a problem with the printer itself).
August 14, 2025
August 14, 2025
Fitment testing of new toolend (hotend and extruder mockup), and began planning for routing part cooling ducts.
Page updated
Google Sites
Report abuse